Yamaha Electone Stagea ELS-01 Owner's Manual page 14

1
Adjusting Parameter Values by Using the Display
Sliders
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
You can adjust some parameters such as Volume, Reverb, Pan and so on, by using the
'virtual' sliders in the display. There are two ways to move the slider in the display:
touching it directly, and using the Data Control dial. We suggest that you touch the
display slider when making coarse adjustments and use the Data Control dial for fine
adjustment.
Touching the display slider directly:
Press a point in the slider to which you want to adjust the parameter value. The slider
will move to the point you pressed. Also, by sliding your finger up or down while
holding down the display slider, you can change the parameter value.
or
Slider will follow your finger
Slider will move to the point you touch
Using the Data Control dial:
Touch on/above the slider in the display to enable the parameter and set a rough value,
then turn the Data Control dial.
Touch here to enable the parameter
DATA CONTROL
Blue mark
To control Pan, you can move the horizontal slider in the same way as vertical sliders.
DATA CONTROL
14 ELS-01/01C Owner's Manual