Cautions For Use - Panasonic PV-GS400 Operating Instructions Manual

Digital video camcorder model no. pv-gs400
Hide thumbs Also See for PV-GS400:
Table of Contents

Advertisement

Available languages

Available languages

PV-GS400Eng.book 82 ページ 2004年6月4日 金曜日 午後3時17分

Cautions for Use

ª After Use
1
Take out the Cassette. (
2
Set the [OFF/ON] Switch to [OFF].
3
Take out the Card. (
-19-
4
Detach the power supply and retract the
Viewfinder or the LCD Monitor. (
5
To protect the Lens, attach the supplied
Lens Cap.
ª Cautions for Use
When you use your Camcorder on a rainy or
snowy day or on a beach, make sure that no
water enters the Camcorder.
≥Water may cause the Camcorder or Cassette to
malfunction. (Irreparable failure may occur.)
≥If sea water splashes onto the Camcorder, wet
a soft cloth with tap water, wring it well, and use
it to wipe the camera body carefully. Then, wipe
it again thoroughly with a soft dry cloth.
Keep the Camcorder away from magnetized
equipment (such as a microwave oven, TV,
video game equipment, etc.).
≥If you use the Camcorder on or near a TV,
images or sounds may be disturbed due to
electromagnetic wave radiation.
≥Do not use near a cell phone because doing so
may cause noise to adversely affect the picture
and sound.
≥Recordings on the tape may be damaged, or
images may be distorted, by strong magnetic
fields created by speakers or large motors.
≥Electromagnetic wave radiation generated by a
microprocessor may adversely affect the
Camcorder, causing the disturbance of images
and sounds.
≥If the Camcorder is affected by magnetically
charged equipment and does not function
properly, turn off the Camcorder power and
detach the Battery or AC Adaptor and then
connect the Battery or AC Adaptor again.
Thereafter, turn on the Camcorder power.
Do not use your Camcorder near radio
transmitters or high-voltage cables.
≥If you record pictures near radio transmitters or
high-voltage cables, recorded images or sounds
may be adversely affected.
Do not use this Camcorder for surveillance
purposes or other business use.
≥If you use the Camcorder for a long period of
time, the internal temperature increases and,
consequently, this may cause malfunction.
≥This Camcorder is not intended for business
use.
82
Others
When you use your Camcorder on a beach or
similar place, do not let sand or fine dust get
into the Camcorder.
≥Sand or dust may damage the Camcorder or
)
-18-
)
Do not spray insecticides or volatile
chemicals onto the Camcorder.
,
)
-16-
-20-
≥If the Camcorder is sprayed with such
≥Do not keep rubber or plastic products in
Do not use benzine, thinner or alcohol for
cleaning the Camcorder.
≥The Camcorder body may be deformed and the
≥Before cleaning, detach the Battery or pull out
≥Wipe the Camcorder with a soft dry cloth. To
≥For storing or transporting the Camcorder, place
After use, be sure to take the Cassette out and
detach the Battery from the Camcorder or pull
out the AC Cable from AC Jack.
≥If the Cassette is left in the Camcorder, the tape
≥If the Battery is left in the Camcorder for a long
ª About AC Adaptor
≥If the temperature of the Battery is extremely
≥If the Battery is warm, charging takes a longer
≥If you use the AC Adaptor near a radio, radio
≥When using the AC Adaptor, it may generate
Cassette. (Care should be taken when inserting
and removing the Cassette.)
chemicals, the camera body may be deformed
and the surface finish may peel off.
contact with the Camcorder for a long period of
time.
surface finish may peel off.
the AC Cable from the AC Jack.
remove stubborn stains, wipe with a cloth that is
soaked in a detergent diluted with water and
afterwards finish wiping with a dry cloth.
it in a bag or case lined with soft pads so as to
prevent the coating on the camera body from
being worn.
sags and deteriorates.
time, the voltage drops excessively, and the
Battery will not function even after it is
recharged.
high or extremely low, the [CHARGE] Lamp
may continue flashing, and the Battery may not
be charged. After the temperature of the Battery
has decreased or increased sufficiently,
charging starts automatically. If the [CHARGE]
Lamp continues to flash even after the Battery
temperature has decreased or increased
sufficiently, the Battery or AC Adaptor may be
faulty. In this case, please contact a dealer.
time than normal.
reception may be disturbed. Keep the AC
Adaptor 3 feet (1 meter) or more away from
radio.
whirring sounds. However, this is normal.

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents