Panasonic PV-GS400 Operating Instructions Manual page 64

PV-GS400Eng.book 64 ページ ２００４年６月４日 金曜日 午後３時１７分
ª To start MotionDV STUDIO
If you wish to capture data from a tape, set the
Camcorder to Tape Playback Mode and insert the
tape. If you wish to capture images from the lens
of the Camcorder, set the Camcorder to the Tape
Recording Mode and remove the tape and the
card.
With USB Connection Cable (supplied)
OS:
Windows XP SP1 or later
Windows 2000 SP4 or later
≥The personal computer should be compatible
with USB 2.0 Hi-Speed.
Confirmation before connection
(for Windows XP/2000)
When you connect the personal computer and the
Camcorder with the USB connection cable and
then use MotionDV STUDIO on Windows XP
(SP1 or later) or Windows 2000 (SP4 or later),
check the driver of the USB host controller.
≥It is required to use the driver for which
[Microsoft] is displayed on [Driver Provider] in
[Driver] tab.
1
Select [Start] >> [Settings] >>
[Control Panel] to start [System].
≥[System Properties] is displayed.
2
Click [Hardware] tab and then click
[Device Manager].
3
Right-click [Enhanced Host Controller] etc.
in [Device Manager] and then select
[Properties].
≥The indication [Enhanced Host Controller] is
changed as [EHCI] depending on the host
controller you use.
4
Click [Driver] tab to check the description
on [Driver Provider].
≥If [Microsoft] is displayed on [Driver Provider],
the confirmation procedure is completed.
64
With a PC
If a description other than [Microsoft] is
displayed
≥Update the driver with the following procedure.
1
Click [Update Driver...].
2
Check [Install from a list or specific location
(Advanced)] and then click [Next].
≥When your OS is Windows 2000, click [Next]
after [Update Device Driver Wizard] appears.
3
(For Windows XP Users)
Check [Don't search. I will choose the driver
to install] and then click [Next].
(For Windows 2000 Users)
Check [Display a list of the known drivers
for this device so that I can choose a
specific driver] and then click [Next].
4
Click [Standard Universal PCI to USB Host
Controller] and then click [Next].
5
Click [Finish].
≥The update of the driver is completed.
Connect the Camcorder.