Registering Cordless Handsets - Sharp UX-BD80 Operation Manual

Registering Cordless Handsets

In order to be used, a cordless handset must first be registered in the
machine. The cordless handset that came with the machine is already
registered. To register an additional cordless handset, follow the steps in
Automatic registration or Custom registration on the following pages.
♦
Use automatic registration when you are only registering the cordless
handset in one base (the machine) and the system PIN number has not
been changed from its initial setting (0000) (see page 67). This is the
easiest method of registration and does not require entering the System
PIN number.
♦
Use custom registration when the system PIN number has been changed
to a number other than 0000. The system PIN number must be entered
during registration.
♦
A cordless handset can be registered in up to four bases. To register the
cordless handset in multiple bases, repeat the custom registration
procedure using each base. To select which base the cordless handset will
normally be used with, see page 70.
Automatic registration
Use automatic registration when you are only registering the cordless handset
in one base (the machine) and the system PIN number has not been changed
from its initial setting (0000).
On the machine
1
Press once and
2
Press once.
3
Press once.
Registering Cordless Handsets
Machine
display:
twice.
DECT SETTING
HS ENTRY
HS ENTRY
PRESS START KEY
65