Connecting The Power Cord - Sharp UX-BD80 Operation Manual

Connecting the Power Cord

Plug the power cord into a 230 V, 50 Hz, earthed (3-prong) outlet.
Caution!
♦
Make sure you have removed all of the packing tape before plugging
in the power cord (see page 18). Plugging in the power cord without doing
so may damage the machine.
♦
The power outlet must be installed near the equipment and must be easily
accessible.
The machine does not have a power on/off switch, so the power is turned on
and off by simply plugging in or unplugging the power cord.
"CHECK CARTRIDGE" normally appears
in the display the first time you plug in the
machine. This message appears until you
install the print cartridge.
Note: If your area experiences a high incidence of lightning or power surges,
we recommend that you install surge protectors for the power and telephone
lines. Surge protectors can be purchased at most telephone specialty stores.
About condensation
If the machine is moved from a cold to a warm place, it is possible that
condensation may form on the scanning glass, preventing proper scanning of
documents for transmission. To remove the condensation, turn on the power and
wait approximately two hours before using the machine.
Connecting the Power Cord
21