On The Remote Control - Pioneer VSA-AX10I-S Operating Instructions Manual

5
Amplifier
AMP
BASS/
TONE
ATREBLE
DVD/LD
VCR1
DISPLAY VIDEO
/DVR
DIMMER SELECT
VCR2
SPEAKER
STATUS
LOUDNESS
A/B
VCR3
SYSTEM
6
TV SETUP MONITOR
7
System Setup
[ Auto Surround Setup
[1. Input Assign]
[2. Surround Setup]
[3. Expert Setup]
[4. THX Audio Setup]
[Exit]
8
Auto Surround Setup
Speaker System Select
[ Normal Surround
[Go Next]
[Return]
10
Auto Surround Setup
•Connect microphone
•Please be quiet
•Move obstacles away
•If you have a subwoofer
turn power on and
turn volume up
[Start]
[Cancel]
Auto Surround Setup
Please Wait
Caution!!
Test tone is
output loudly.
[Cancel]
Auto Surround Setup
Now Analyzing
Environment Check
Ambient Noise
Microphone
Speaker Level
[Cancel]
5
5 Press AMP then press the SUB button

on the remote control.

MAIN SUB REMOTE
SETUP
CD
6 Press the SYSTEM SETUP button and
CD-R/
TAPE1
EFFECT/
CH SEL. use the on-screen display (OSD) that
TUNER
VIDEO
appears on your TV.
INPUT
ATT.
SAT
TAPE 2 SIGNAL
TV
SELECT
CONTROL
7 The arrow should be pointing at AUTO
SURROUND SETUP, press ENTER.
8 NORMAL SURROUND should be
selected. (Use the 23 buttons to select
it if it isn't.) Use the 5∞ buttons to
]
select GO NEXT and press ENTER.
For FRONT BI-AMP 5.1 settings see page 73.
RETURN brings you back to the system setup menu.
9 Some auto setup instructions will be
listed, make sure to follow them.
Make sure you have: hooked up the microphone and
]
moved obstacles to the speakers out of the way. If you
have a subwoofer make sure it is turned on and has the
volume turned up.
WARNING: The test tones are very loud!! Make sure
there are no infants or small children in the room and
that no one who will be scared, upset or injured by loud
noise is present. You yourself may want to wear ear-
plugs. If you lower the volume of test tones with the
master volume, the result will likely be incorrect speaker
settings.
10 If you have followed all setup
instructions and warnings above make
sure that the arrow is pointed to
START and press ENTER. Be prepared
for loud test tones.
Try to be as quiet as possible after hitting ENTER. The
test tones may take up to 30 seconds.
The volume automatically increases to 0dB, then the
system will output some test tones and establish
ambient noise levels, the microphone status, and what
speakers you hooked up.
•••
[OK]
[OK]
[OK]
Quick Start Guide Part2
15
En