Assigning The Component Video Inputs - Pioneer VSA-AX10I-S Operating Instructions Manual

Advanced Setup

Assigning the Component Video Inputs

If you used component video cords (and only if you did so) to connect any equipment you must tell the
amplifier which device is hooked up with this special kind of cable. If you did not use component video
cord (which is a specialized cord that separates the video signal into two color spectrums and a light
spectrum for transmission) then you don't need to worry about the procedure below. The default settings
for the component video inputs are off.
1
Amplifier
AMP
TONE
DVD/LD
VCR1
DISPLAY
/DVR
DIMMER
VCR2
STATUS
VCR3
3
SYSTEM
TV SETUP
4
System Setup
[ Auto Surround Setup ]
[1. Input Assign
[2. Surround Setup]
[3. Expert Setup]
[4. THX Audio Setup]
[Exit]
5
1.Input Assign
[ 1.Digital-In ]
[ 2.Component Video In
[ 3.i.LINK Input ]
[Return]
6
1.2. Component Video In
Component-1
Component-2 [ OFF
Component-3 [ OFF
[Return]
7
1.2. Component Video In
Component-1 [DVD/LD ]
Component-2 [
Component-3 [ OFF
[Return]
memo If you connect the TV monitor with com-
ponent video cord, and the DVD player
with composite or S video cord then you
should set that terminal to off.
86
En
2
MAIN SUB REMOTE
SETUP
BASS/ CD
ATREBLE
CD-R/
TAPE1
EFFECT/
CH SEL.
TUNER
VIDEO
SELECT
VIDEO
SPEAKER INPUT
LOUDNESS
A/B ATT.
SAT
TAPE 2 SIGNAL
TV
MONITOR
SELECT
CONTROL
]
]
[DVD/LD ]
]
]
VCR1 ]
]
1 Turn on the amplifier and your TV,
press the AMP on the remote
control.
2 Press the SUB button on the remote
control.
3 Press the SYSTEM SETUP button.
4 Looking at the on-screen display on
your TV, use the 5∞ buttons to
select INPUT ASSIGN. Press the
ENTER button.
5 Use the 5∞ buttons to select
C'NENT VIDEO IN. Press the ENTER
button.
6 Use the 5∞ buttons to move
through the different component
video input settings and use the 2 3
buttons to select the component
that you hooked up to that
component video in.
If you're not sure which component is connected to
which component video in, look on the back of the
amplifier and check the cables you connected.
7 When you're finished use the 5∞
buttons to select RETURN and press
ENTER.
You will leave the "Assigning the Component Video
Inputs" mode.
8 Use the 5∞ buttons to select
RETURN and press ENTER, again.
Then, use the 5∞ buttons to select
EXIT and press ENTER.