Displays & Controls; Front Panel - Pioneer VSA-AX10I-S Operating Instructions Manual

Displays & Controls

Front Panel

All the controls on the front panel are explained and/or referenced here. To open the front panel push
gently on the lower third of the panel.
1
STANDBY/ON
OFF
11
1 INPUT SELECTOR dial
Turn to select a source component. The input
indicators show the current component.
2 STANDBY/ON button and power ON
_/OFF — button
Press to switch the amplifier ON or into
STANDBY mode. You can't operate the amplifi-
er when the mechanical power button is in the
OFF (—) position.
3 STANDBY indicator
Lights when the amplifier is in STANDBY
mode. (Please note that this amplifier
consumes a small amount of power [0.65 W] in
the standby mode.)
4 Remote sensor
Receives the signals from the remote control.
5 Display (see p.39)
32
En
2 3 4
Î
STANDBY
ON
INPUT SELECTOR
13
12
19 20 21 22
5
VIDEO AUDIO
14 15 16
24
23 25
6 MCACC indicator (see p.58)
Lights when the ACOUSTIC CAL EQ is on.
(After the Auto Surround Sound Setup has
been completed the ACOUSTIC CAL EQ is set
on and this display will light.)
7 i.LINK indicator (see p.50, step 3)
Lights when an i.LINK-Audio-equipped compo-
nent is selected.
8 INPUT indicators
Shows which source component is selected.
The MULTI CH INPUT indicator lights when a
component connected to MULTI CH INPUT is
selected. When an unassigned i.LINK-equipped
component is selected, no INPUT indicator will
light.
9 LISTENING MODE SELECTOR dial (see
p.51, step 6)
Turn and push to select a listening mode.
6 7 8
AUDIO/VIDEO MULTI-CHANNEL AMPLIFIER
LISTENING MODE SELECTOR
PUSH ENTER
MASTER VOLUME
17
18
26
9 10
VSA-AX10i