Using I.link Interface; What Is I.link; Connecting I.link-Equipped Components - Pioneer VSA-AX10I-S Operating Instructions Manual

Using i.LINK Interface

What is i.LINK?

i.LINK is a trademark name for IEEE1394, a high-speed interface for digital audio, video and other data
found on personal computers, digital camcorders, and other kinds of audio and audio/visual equipment. A
single i.LINK connector can both send and receive data at the same time, so only one cable is required to
connect components for two-way communication.
This amplifier is compatible with i.LINK Audio interface. With this interface you can enjoy digital audio
from SACD and DVD-A discs (if the player is compatible with these outputs), as well as digital audio from
DVD-Video, CD and Video CD discs.
When playing CD or SACD discs over an i.LINK connection, the digital audio is jitterless if the connected
player is compatible with PQLS (see PQLS p.3). See the operating instructions that came with your i.LINK
components for information on compatibility with these features.

Connecting i.LINK-equipped Components

If you have a component (such as a DVD player) with an i.LINK connector, you can connect it to the i.LINK
connectors on the rear of your amplifier as shown below.
The i.LINK interface does not transmit video signals. So when you connect video components with i.LINK
cable, the video signal must be connected with other cables. Hook up the video signal with either compo-
nent video, S video, or composite video cords (see p.18) to available VIDEO IN terminals. If you've already
hooked up the video signal from the component, assign the i.LINK input to the input function to which
you've connected the video signals (see p.87).
The two i.LINK connectors on the rear of your amplifier are 4-pin connectors. Use a 4-pin, S400 i.LINK
cable to connect i.LINK-equipped components.
Before making or changing connections, switch off the power and disconnect the power cord from
the AC outlet.
*The arrows indicate the direction of the video signal.
DIGITAL
PCM/2DIGITAL
/DTS/MPEG
2
OUT
AUDIO
R
PHONO
1
OUT IN
7
CD
(CD-R/
TAPE1
IN
/MD)
IN
6
TUNER
(VCR2)
IN
IN
5
OUT
(VCR1
REC
/DVR)
CD-R/
IN
TAPE1
4
/MD
(SAT) IN
PLAY
IN
OUT
3
IN (CD) REC
TAPE2
MONITOR
2 IN
(TV)
IN
PLAY
FRONT
(DVD
1
IN
/LD)
R
SUR-
ROUND
(DVD
2RF
IN
/LD)
R
(For LD)
ASSIGNABLE
CONTROL
S400 (AUDIO)
OUT IN
L
DVD
/LD
IN
AUDIO
POWER
TV
AMP
IN
IN
R L
FRONT
SAT
IN
R L
CENTER
OUT
VCR1
SUB W.
/DVR
PRE OUT IN
1
2
(Single)
SUR-
ROUND
OUT
R L
VCR2
SUR-
ROUND
BACK
IN
R L
(Single)
CENTER
SUB W.
OUT
L
VCR3
SUR-
ROUND
IN
BACK
L R L (Single)
R L
MULTI CH INPUT
AUDIO VIDEO
MONITOR
OUT
i.LINK component
MONITOR
OUT
IN
i.LINK
IN
connection
IN
OUT
IN
OUT
IN
OUT
IN
CAUTION:
S VIDEO
If your i.LINK connector comes into
contact with metallic parts of the
amplifier other than the intended
connector an electrical short may occur.
Please take care to connect it to the
proper i.LINK connector only.
Video connection
29
En