Dynamic Range Control - Pioneer VSA-AX10I-S Operating Instructions Manual

Advanced Setup

DYNAMIC RANGE CONTROL

This feature makes it possible to enjoy full surround sound effects even at low volumes. It does this by
compressing the dynamic range. Dynamic range is the difference between the loudest and the softest sounds in
any given signal. Compressing the range plays sounds so the quieter ones are audible and the louder ones don't
get distorted or become overpowering. If continuing from BASS PEAK LEVEL, DYNAMIC RANGE CONTROL
should be selected.
5˜∞˜2˜3˜ENTER buttons
1
3.Expert Setup
[1. OSD Adjustment ]
[2. Bass Peak Level ]
[3. D-Range Control
[4. Multi-Ch In Select ]
[5. Function Rename ]
[6. Hi-bit/Hi-sampling ]
[Return]
2,3
3.3. Dynamic Range
Compression Level
dts
[Return]
92
En
STANDBY/ON
ENTER
]
Control
[MID]
[OFF]
Follow steps 1-4 on page 89, if necessary, to get to the
starting point mentioned here.
1 D-RANGE CONTROL should be
selected if it isn't use the 5∞
buttons to select it. Press ENTER.
2 Use the 2 3 buttons to choose
either OFF, MID or MAX.
OFF: No Dynamic Range Control.
MID: A moderate amount of Dynamic Range Control.
MAX: The most Dynamic Range Control available is
applied.
3 Use the 5∞ buttons to select
RETURN. Press ENTER button.
Dynamic Range Control is set. Go on to the next
setting.
If you want to change a setting before proceeding
Start over from step one.
You may need to experiment with different sources
before you can use the DYNAMIC RANGE CONTROL
setting to suit your low volume listening needs.
4 If you want to continue EXPERT
SETUP use the 5∞ buttons to select
the next setup and press ENTER.
Go on to the next page.
5 If you want to finish EXPERT SETUP
use the 5∞ buttons to select
RETURN and press ENTER. Then use
the 5∞ buttons to select EXIT and
press ENTER.
If you are listening at loud volumes we recom-
memo
mend turning the DYNAMIC RANGE CONTROL
OFF.