Table of Contents
Advertisement
Using the blank skip function
Automatically carriers out fast forward to the start of
the next selection when there is a blank area of 10
seconds
of more between selections
1 , Press
button [16] and frame [44] will light. The unit
will naw carry out fast forward to the start of the
next selection when there is a blank area of 10
seconds or more between selections.
2. To release the blank skip function, press button
16] again,
Using the Music Repeat Function
Lets you listen to the same selection repeatedly.
1. When you want to listen to the same selection
repeatedly, press button [14] and frame [42] will
fight.
2. To release the music repeat function, press button
{14} again or press button [11].
Using the Remote Control
oa
Batteries
. Remove the battery compartment cover from the
remote controller unit.
2. Load two batteries, whose type is UM-4.
RO3, as applicable, that come with the u
remote controller unit, ensuring that th
(+/+) is correct.
3. Replace the battery compartment cover.
AAA of
it into the
r polarity
Precautions When Loading Batteries
Note the following precautions when loading
batteries into the remote controller unit to avoid
damage due to battery fluid leakage.
+
Always check carefully that you are loading
s with their {+} and (-} poles facing in the
proper
directions.
+
Never mix ofd and new batteries. Always replace
batteries with two new ones.
+
Some batteries may appear to be identical but
have different voltage ratings. Never mix battery
types.
+
Some batteries can be recharged and some
cannot. Be sure to carefully read the label for the
batteries
you use.
+
To avoid damage to the remote controller caused
by battery leakage, remove the batteries from the
remote controller if you do not plan to use it for
more than one month. If you find that fluid has
leaked, thoroughly wipe out the battery
compartment and load a set of new batteries.
Precautions
«
Keep the remote controfler unit in an area not
exposed to long periods of direct sunlight.
+
The remote controller unit may not operate
properly if the transmitter of the remote controller
unit is pointed towards the floor or the seat of the
vehicle.
+
Since the transmitter employs and infrared system,
it may not operate properly while car stereo unit is
exposed to direct sunlight. In such a case. block
the sunlight from the sensor and then perform the
desired operation.
»
ff the remote controler fails to operate untess it is
brought close to the unit, it may indicate that
battery power is low. Replace the batteries in the
remote controller.
1
Advertisement
Table of Contents
