Every 100 Hours; Engine Oil; Change The Engine Oil - Cub Cadet Sc2400 Operator's Manual

5. Every 100 Hours

■ Engine Oil

Use an oil of the viscosity appropriate for the air
temperature range expected until the next oil change
interval.
Engine crankcase
Capacities
API Service Classifications
Approximately
CF or higher
2.2 US qt. (2.1 L)
SAE 10W-30 or SAE 10W-40

■ Change the Engine Oil

! WARNING ! WARNING
●When draining away the engine oil that is still
hot, stay clear of the hot engine oil and other
components to avoid burn.
IMPORTANT: Avoid damage.
●Change the engine oil more frequently if the tractor
is used in extremely demanding conditions:
• Extremely dusty conditions
• Frequent slow- or low-speed operation
• Frequent short trips
1. Run the engine to warm up the engine oil.
2. Park the tractor safely on a level surface.
3. Open the hood.
4. Place an engine oil pan beneath the engine oil
drain plug.
(A) Drain plug
5. Remove the drain plug by turning
counterclockwise and allow the oil to drain.
6. Reinstall the drain plug. Do not over-tighten it.
7. Remove the oil fill cap.
8. Add approximately 2.2 US qt. (2.1 L) of the
engine oil.
9. Reinstall the oil fill cap.
10.Start and idle the engine to check for any leaks.
11.If there is any leakage, stop the engine, close the
hood and contact your local Cub Cadet Yanmar
for technical assistance.
12.Check the engine oil level and add more as
necessary.
13.Close the hood.
14. PERIODIC SERVICE
Lubricants
14-26
The following oils are recommended:
3013738
(A)
P3014926
Sc2400 Operator's Manual