Cub Cadet Sc2400 Operator's Manual page 39

(24)4-wheel drive lever
In the 4-wheel drive mode, all the four wheels are
powered to obtain better traction on difficult-to-travel
ground.
The 4-wheel drive lever can be set to the ON or OFF
position only when the tractor is at a standstill.
(A) 4-wheel drive lever
(a) 4-wheel drive mode
(b) 2-wheel drive mode
IMPORTANT: Avoid damage.
●ALWAYS keep the 4-wheel drive lever in the OFF
position when traveling on a paved surface.
●ALWAYS disengage the 4-wheel drive lever when
not needed to prevent premature wear of the front
tires.
●NEVER install tire chains to the front wheels.
Chains will hit and can damage the tractor.
●If disengaging the 4-wheel drive lever is difficult,
stop the tractor, turn the steering wheel right and
left several times. Then attempt to disengage the
4-wheel drive lever again.
●To minimize tire wear, drive in the 4-wheel drive
mode only when absolutely necessary. Driving the
tractor on a paved road in the 4-wheel drive mode
can accelerate wear of the tires.
●To obtain better traction, keep the front tires at the
maximum allowable pressure.
●When the 4-wheel drive lever is in the ON position,
braking will apply to all four wheels.
(25)Hydraulic flow control/stop knob
The lowering speed of the lower link is governed by
the position of the hydraulic flow control/stop knob.
Also, this knob is used to stop the lower link at an
intended position.
(A) Hydraulic flow control/stop knob
(a) Turning the knob clockwise will cause the
lowering speed to decrease.
Tighten the knob by fully turning clockwise to stop
the lower link.
(b) Turning the knob counterclockwise will cause the
lowering speed to increase.
5. NAMES AND FUNCTIONS OF COMPONENTS
(A)
(a)
3014904b
(b)
(A)
3014904d
5-10
(b)
(a)
Sc2400 Operator's Manual