Base Unit - Panasonic KXTG8521E Operating Instructions Manual

TG8521E(e).book Page 32 Wednesday, March 17, 2010 3:39 PM
Programming
L When you purchase an additional
handset, refer to the additional
handset's installation manual for
registration.
Selecting a base unit
When "Auto" is selected, the handset
automatically uses any available base
unit it is registered to. When a specific
base unit is selected, the handset makes
and receives calls using that base unit
only. If the handset is out of range of that
base unit, no calls can be made.
1
1 (centre of navigator key) i
{#}{1}{3}{7}
2
{V}/{^}: Select the desired base
unit number, or "Auto". i M
L The handset starts searching for
the base unit.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored to the
base unit. This allows the handset to end
its wireless connection with the system.
1
1 (centre of navigator key) i
{#}{1}{3}{1}
L All handsets registered to the
base unit are displayed.
2
{V}/{^}: Select the handset you
want to cancel. i M
3
{V}/{^}: "Yes" i M
L A confirmation tone sounds.
L The handset does not beep when
cancelling its own registration.
4
{ic}
Cancelling a base unit
A handset can cancel a base unit that it
is registered to. This allows the base unit
to end its wireless connection with the
system.
32
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
1
1 (centre of navigator key) i
{#}{1}{3}{9}
2
{V}/{^}: Select the base unit you
want to cancel. i M
3
{V}/{^}: "Yes" i M i {ic}
Note:
L To register a handset to another base
unit or to the same base unit again,
see page 31.
Increasing the range of the

base unit

You can increase the signal range of the
base unit by using a DECT repeater.
Please use only the Panasonic DECT
repeater noted on page 4. Contact your
Panasonic dealer for details.
Important:
L Before registering the repeater to this
base unit, you must turn the repeater
mode on.
L Do not use more than one repeater at
a time.
Setting the repeater mode
1
1 (centre of navigator key) i
{#}{1}{3}{8}
2
{V}/{^}: Select the desired setting.
i M i {ic}
Note:
L After turning the repeater mode on or
off, _ is displayed on the handset
momentarily. This is normal and the
handset can be used once w is
displayed.