Panasonic KXTG8521E Operating Instructions Manual page 52

TG8521E(e).book Page 52 Wednesday, March 17, 2010 3:39 PM
Useful Information
Programmable settings
Problem Cause/solution
The display is in a L Change the display language (page 14).
language I cannot
read.
While programming, L A call matching an entry in the call barred list is being
the display returns to
standby mode.
I cannot activate the L You cannot set eco mode when you set the repeater
eco mode.
I cannot register a L The maximum number of base units (4) is already
handset to a base unit.
L The maximum number of handsets (6) is already
L You entered the wrong PIN. If you forget your PIN, see
I cannot remember the L Change the PIN using the following method.
PIN.
Battery recharge
Problem Cause/solution
The handset beeps L Battery charge is low. Fully charge the batteries (page
and/or ) flashes.
I fully charged the L Clean the battery ends (S, T) and the charge
batteries, but
– ) still flashes or L It is time to replace the batteries (page 9).
– the operating time
seems to be shorter.
The handset display is L The handset is not turned on. Turn the power on (page
blank.
52
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
received. Wait and try again later.
mode "On". If required, set the repeater mode to
"Off" (page 32).
registered to the handset. Cancel unused base unit
registrations from the handset (page 32).
registered to the base unit. Cancel unused handset
registrations from the base unit (page 32).
"I cannot remember the PIN." (page 52).
1
1 (centre of navigator key) i {#}{1}{3}{2}
2
{*}{7}{0}{0}{0}
3
Enter the new 4-digit base unit PIN. i M i
{ic}
9).
contacts with a dry cloth and charge again.
14).