Changing The Handset Name - Panasonic KXTG8521E Operating Instructions Manual

TG8521E(e).book Page 29 Wednesday, March 17, 2010 3:39 PM
L You can select 24-hour or 12-
hour clock format ("AM" or "PM")
by pressing /.
4
Enter the desired hour and minute
you wish to end this feature. i
M
5
{ic}
L When the night mode is set, 3 is
displayed.
Note:
L To correct a digit, press {<} or {>} to
move the cursor to the digit, then
make the correction.
Changing the start and end time
1
1 (centre of navigator key) i
{#}{2}{3}{7}
2
Continue from step 3, "Turning night
mode on/off", page 28.
Setting the ring delay
This setting allows the handset to ring
during night mode if the caller waits long
enough. After the selected amount of
time passes, the handset rings. If you
select "No Ringing", the handset
never rings during night mode.
1
1 (centre of navigator key) i
{#}{2}{3}{9}
2
{V}/{^}: Select the desired setting.
i M i {ic}
Note:
L When the answering system answers
the call, this feature does not work.
Selecting categories to bypass night
mode
1
1 (centre of navigator key) i
{#}{2}{4}{1}
2
{V}/{^}: Select your desired
categories. i t
L "Q" is displayed next to the
selected category numbers.
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Programming
L To cancel a selected category,
press t again. "Q" disappears.
3
M i {ic}
Note:
L You can also select the categories in
step 2 as follows:
Press {1} to {9}. i M

Changing the handset name

Each handset can be given a
customised name ("Bob", "Kitchen",
etc.). This is useful when you make
intercom calls between handsets. You
can also select whether or not the
handset name is displayed in standby
mode. The default setting is "Off". If
you select "On" without entering any
handset name, "Handset 1" to
"Handset 6" is displayed.
1
1 (centre of navigator key) i
{#}{1}{0}{4}
2
Enter the desired name (max. 10
characters; page 48).
L If not required, go to step 3.
3
M
4
{V}/{^}: Select the desired setting.
i M 2 times
5
{ic}
Incoming call barring (Caller
ID subscribers only)
This feature allows the unit to reject calls
from specified phone numbers that you
do not want to answer such as junk calls.
When a call is received, the unit does not
ring while the caller is being identified. If
the phone number matches an entry in
the call barred list, the unit sends out a
busy tone to the caller, and then
disconnects the call.
29