Registering A Unit - Panasonic KXTG8521E Operating Instructions Manual

TG8521E(e).book Page 31 Wednesday, March 17, 2010 3:39 PM
L To cancel a selected handset,
press t again. "Q" disappears.
4
M
5
{V}/{^}: Select a memory location.
i M
6
Enter the phone number or area
code to be restricted (8 digits max.).
i M i {ic}
L To erase a restricted number,
press ^.
Note:
L You can also select a memory location
in step 5 as follows:
Press {1} to {6}. i M

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to a
single base unit.
Important:
L The additional handset model
recommended for use with this unit is
noted on page 4. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Additional base units
Handsets can be registered to up to 4
base units, allowing you to add
additional base units and extend the
area in which your handset(s) can be
used. If a handset moves out of range of
its base unit when "Auto" is selected on
base unit (page 32), it looks for another
base unit to make or receive calls. A
base unit and the handsets it
communicates with is called a "radio
cell".
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Programming
Note:
L Calls are disconnected when the
handset moves from one radio cell to
another.
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, _ is displayed even when
the handset is near the base unit), re-
register the handset.
1
Handset:
1 (centre of navigator key) i
{#}{1}{3}{0}
2
{V}/{^}: Select a base unit number.
i M
L This number is used by the
handset as a reference only.
3
Base unit:
Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
4
Handset:
Wait until "Base PIN" is displayed.
i Enter the base unit PIN (default:
"0000"). i M
L If you forget your PIN, see page
52.
L When the handset has been
registered successfully, w is
displayed.
Note:
L While registering, "Base in
registering" is displayed on all
registered handsets.
31