Mitsubishi TRIUM ECLIPSE User Manual page 35

for the WAP™ gateway then press OK
5
Select Home page and edit a URL address, then press OK
validate.
6
Select Activate security (Never, Automatic or Always
requested for secure transactions such as mobile banking), then
press Select
7
Select a Normal port corresponding to the connection or Secure
port for a secure connection, then press OK
8
Select Send Characteristics to send or not the UA profile, to
the remote server and press Select
Select Yes. Stored will appear.
9 Select Circuit access, and edit a Phone number to dial up the
WAP™, a Login name, used for identification (29 char. max.), a
Login password used for access control (19 char. max.; each
character will turn into a star (*) after a short while), a Speed
(9600 or 14400 bps), a Mode for transmission (digital or analog)
to the remote modem, an Auto-disconnect duration (0 to
60 minutes) for automatic disconnect after a defined time with
no activity on the WAP™ connection. Validate each entry by
pressing OK
will appear.
Select Packets access*, and edit an Access point name from
10
the GPRS network (the name is picked from a list managed in the
mobile) and an Auto-disconnect duration.
Press OK
Stored will appear.
Select Connection mode and select the mode of connection:
11
Circuit, Packet* or Circuit+packet. Press Select
date. Press End
Select Push parameters and edit a Push Proxy SMS centre, a
12
Push Proxy SMS address or Push Proxy IP address by select-
ing from a predefined list (except IP address): press Names
select an entry from the list and press OK
Press End
13
and press Select
A WAP™ profile has to be selected for the preferred WAP™ access.
To select a WAP™ profile:
1
. Select Internet.
Press
2 Select Profile list. Select the preferred profile and press
Options
3 Select Select.
4
Up to 20 bookmarks can be stored for frequent access.
* GPRS availability is operator dependent
to validate.
or Select . Press End
, every time, to validate. Press End
. Select Yes. Stored will appear.
. Stored will appear. Select Yes to store the new data
. The new profile appears in the profile list.
.
to validate.
to validate.
to validate. Press End
. Select Yes. Stored
. Select Yes.
to vali-
to validate.
to
.
and
35