Service Messages - Konica Minolta MAGICOLOR 2300W User Manual

Service Messages

A service message sometimes occurs as a result of an unusual combination
of events, not because of an actual problem. When the printer stops and a
service message displays in the Status Display message window, turn the
printer off and then back on. This often clears the service message indicator,
and printer operation resumes. Always try this before making a service call.
Service calls should be placed to the vendor from whom you purchased
the printer. If you cannot get service from your vendor, see the Service &
Support Guide for a list of sources of service and support in many areas of
the world. The most current worldwide information can be found at
www.konicaminolta.net/printer/.
This service
message...
AIDC Sensor Error
Communication
Error
Controller
Internal Error
SDRAM Error on
Board
100
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
means...
AIDC sensor error.
A communication error
occurred in the parallel
or USB interface.
There is an internal error
on the controller board.
There is an SDRAM
error on the controller
board.
Status, Error, and Service Messages
do this...
Contact Technical
Support with the error
information.
Check that the interface
cable is properly
connected to the printer.
If the error continues to
appear even though the
cables are correctly
connected, contact
Technical Support.
Contact Technical
Support with the error
information.
Contact Technical
Support with the error
information.