To Use Finisher Manually - Konica Minolta FS-505 User Manual

2

To use finisher manually

0 Paper should be placed only in the lower tray of the Cover Sheet Feeder.
Upper tray cannot be used.
0 Staple (Corner staple / 2 position staples) and Punch can be used in
combination.
0 The size and the number of sheets of the loaded paper differ depending
on the finisher operations to be used. For details, refer to page 2-9.
0 The Punch settings cannot be used with special paper, such as overhead
projector transparencies, label sheets and diazo photosensitive paper. If
a Punch setting is used with special paper, the punch kit may be
damaged.
1
Place a set of paper in the lower tray
of the Cover Sheet Feeder.
– Staple (Corner staple / 2 position
staples): Place paper face up.
– Punch: Place paper face up.
2
Align the guide plate with the paper.
3
Press Staple mode selection button and Punch button to select the
desired mode.
– To select Staple (Corner staple / 2 position staples), press Staple
mode selection button to turn on the desired mode lamp.
– To select Punch, press Punch button to turn on the lamp.
To use Staple in combination, turn on the desired Staple mode
lamp.
To select only the Punch mode, turn off all the other mode lamps.
2-20
Staple mode selection button
Punch button
Copy operations
Lower tray
Start/Stop button
Finisher FS-505