When The Message "The Fuser Oil Has Run Out." Appears; Replenishing The Fuser Oil - Minolta CF9001 Operator's Manual

5. When the Message "The Fuser Oil has run out." Appears

Usually, the Fuser Oil replenishment should be performed by a qualified service representative.
However, on an as need basis, the Copier can be set so that a trained operator can replenish the
Fuser Oil. In this case, we recommend that only a trained key operator replenish the Fuser Oil
according to the following procedure.

Replenishing the Fuser Oil

Open the Front Door.
1
The message shown on the left appears when the
Fuser Oil is running out. You can still make copies,
but it is recommended that you replenish the Fuser Oil
as soon as possible.
1179P427CA
When Fuser Oil has run out, the message shown on
the left appears and you can no longer start a new
copy cycle. Replenish the Fuser Oil by following the
procedure given below.
1179P426CA
Turn the Lever
2
Lever
Fusing Unit.
1179O025AA
M4 to the left. Grasp the
M6 and slide out the Transfer/
M6
M4
6-14
1144L027AA