Table of Contents
Advertisement
3. If paper jams
If a paper misfeed occurs, copying will stop and a message will appear on the touch panel about the misfeed. Leave the main switch ON ( | ) and
refer to "(3) Removal procedures" to remove the jammed paper.
Inch specification
Paper misfeed.
JAM 00
(1) Cautions
WARNING
High voltage is present in the charger section. Take
sufficient care when working in this area, as there is
a danger of electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take
sufficient care when working in this area, as there is
a danger of getting burned.
* Do not reuse misfed paper.
* If paper is torn during removal, be sure to remove any loose scraps
of paper from inside the copier, or they could cause another misfeed
later.
* Once misfed paper has been removed, warm-up will begin, the
misfeed indication will go out, and the copier will return to the same
settings prior to the misfeed.
* If a misfeed occurs in the Document Finisher, it is not necessary to
add the misfed copy to the other copies that are already ejected into
the tray, as that copy will be automatically made again.
1.Open front cover.
Section 9 TROUBLESHOOTING
Metric specification
Paper misfeed.
JAM 00
(2) Misfeed location indicators
Paper misfeed.
JAM 00
3 5
6
1 Misfeed in a paper feed area (page 9-8)
2 Misfeed in the paper conveyor section (page 9-13)
3 Misfeed in the fixing section or the ejection section (page 9-14)
4 Misfeed in the Duplex Unit (page 9-17)
5 Misfeed in the Document Processor (page 9-19)
6 Misfeed in the optional Document Finisher (page 9-20)
1.Open front cover.
1.Open front cover.
2
1
4
1
9-7
Advertisement
Table of Contents
