Key Counter - Kyocera KM-1620 Operation Manual

Section 8 TROUBLESHOOTING
Display
"E91" appears on the copy quantity display.
"OP" appears on the copy quantity display.
"OP1" appears on the copy quantity display.
"OP2" appears on the copy quantity display.
"OP3" – "OP5" appears on the copy quantity
display.
"C" and a number are alternately displayed on
the copy quantity display.
"A" and a number are alternately displayed in
the copy quantity display. (except A-3200)
"A3" and "200" are displayed alternately in the
copy quantity display.
The Paper Misfeed display blinks on and off and
"JXX" appears on the copy quantity display.
XX indicates the paper misfeed location
numerically.
"OF" appears on the copy quantity display.
The Periodic Maintenance indicator blinks on
and off.
The Periodic Maintenance indicator lights up.
The Paper Supply indicator lights up and "PE"
appears on the copy quantity display.
"PF" appears on the copy quantity display.
"U1 appears on the copy quantity display.
"= = =" appears on the copy quantity display.
"-" appears on the copy quantity display.
"---" appears on the copy quantity display.
8-2
Corrective Procedure
Copies cannot be produced because memory is full during the interrupt
copy operation. Interrupt Copying cannot be carried out so press the
[Stop/Clear] key and then press the [Interrupt] key again after the data
read in has been deleted to exit the Interrupt Copying.
After the copying operation for the interrupted copy has been completed,
repeat the procedure again.
The front cover of the copier is open. Close the front cover.
The left cover of the Document Processor is open. Close the left cover. Close
the front cover.
The left cover of the copier is open. Close the left cover.
The left cover of the optional drawer is open. Close each of the left covers.
Make a note of the C and the number. Turn the power switch OFF, unplug
the power cord and contact your service representative.
Turn the power switch OFF/ON. Usage will be possible again once the
regular display returns. When A and the number are again displayed on
the copy quantity display, make a note of the A and the number. Turn the
power switch OFF, unplug the power cord and contact your service
representative.
Condensation is occurring within the copier. Turn the Power Switch OFF
and then turn it ON again after 10 to 20 minutes have elapsed.
A paper misfeed has occurred. Remove the jammed paper.
250 copies have been stored in the storage section. Remove the paper, press
the [Start] key and resume copying.
This is a notification that the time for periodic maintenance is approaching.
It is time for Periodic Maintenance. Contact your service representative.
There is no paper in the drawer level that corresponds to the lighting
indicator. Replenish the paper and set the drawer.
Check the Multi-bypass Tray paper. Set paper in the Multi-bypass Tray in
the event there is no paper present there. When the Multi-bypass Tray
paper fails to be fed, reset the paper.
Check the key counter or key card and make sure it is set properly.
Department Management being set. Use the Keypad to enter the assigned
Section Code to perform copying operations. Press the [Management] key
after copying is finished to display "= = =" again.
The copier is in the Off mode setting. Press the [Energy Saver] key to exit
the mode.
The copier is in the Low Power mode setting. Press any key to exit the
mode or in the case where the optional Document Processor is installed, set
an original in the Document Processor.
Reference
Page
–
–
–
–
–
–
8-3
–
–
–
3-1
3-4
7-4
6-6
4-8
4-7