Inputting Custom Sizes - Kyocera KM-1620 Operation Manual

Section 3 PREPARATIONS

Inputting Custom Sizes

Sizes that are not displayed on the Operation Panel are registered
as Custom Sizes.
1
Press the [Exposure Adjustment] keys on both sides for 3
seconds. "F00 (Default Setting Mode)" will be displayed in
the No. of Copies display.
Inch specifications
2
Press either the Zoom (+) or Zoom (–) key to display the
"F22 (Custom1 Size)".
Inch specifications
3
Press the [Enter] key.
Inch specifications
3-6
Metric specifications
Metric specifications
Metric specifications
4
Press either the Zoom (+) key or the Zoom (–) key and select
the size. The paper sizes displayed are as shown in the
table below. When selecting Irregular Sizes, carry out the
following procedure. In the case of the selection of other
sizes, proceed to Step 9.
Inch specifications
Display: Sizes
Inch specifications
(b5E): B5 Vertical
(b6r): B6 Horizontal
(A6r): A6 Horizontal
(PoS): Postcard
(Ldr): Ledger Horizontal
(LGr): Legal Horizontal
(Ltr): Letter Horizontal
(LtE): Letter Vertical
(Str): Statement Horizontal
(o2r): Oficio II
(CPF): 11" × 15" Horizontal
(InP): Irregular Size
5
Press the [Enter] key. The Width can be input after 2
blinks.
Inch specifications
Metric specifications
Metric specifications
(A3r): A3 Horizontal
(A4r): A4 Horizontal
(A4E): A4 Vertical
(A5r:): A5 Horizontal
(b4r): B4 Horizontal
(b5r): B5 Horizontal
(b5E): B5 Vertical
(b6r): B6 Horizontal
(A6r): A6 Horizontal
(PoS): Postcard
(For): Folio Horizontal
(o2r): Oficio II
(CPF): 11" × 15"
Horizontal
(InP): Irregular Size
Metric specifications