Drawer Size Detection - Kyocera KM-1620 Operation Manual

Note
When loading paper into the drawer, set it so that the
side that is to be copied faces upwards.
6
Set the accompanying paper sheet so that the paper size set
in the drawer can be identified from the front of the drawer.
7
Gently push in the drawer.
Note
When the copier will not be used for a long period of time,
remove the paper from the drawer or feeder, put it in a
storage bag and seal the bag in order to protect the paper
from humidity.

Drawer Size Detection

Set the Size Detection on the operation panel to match the size of
the paper loaded in the drawer. The copier has been set at the time
of shipping for automatic detection in inch units for inch
specifications, or in centimeter units (A⋅B columns) for metric
specifications.
1
Press the [Paper Select] key for 3 seconds. The Default
Settings Mode will be displayed.
Inch specifications Metric specifications
Section 3 PREPARATIONS
2
Press either the Zoom (+) or Zoom (–) key to display the
"F17 (Drawer 1 Paper Size)".
Inch specifications
Note
When setting the size of the optional drawer (2 - 4),
display F18 (Drawer 2 Paper Size), F19 (Drawer 3 Paper
Size) and F20 (Drawer 4 Paper Size).
3
Press the [Enter] key.
Inch specifications
4
Press either the Zoom (+) key or the Zoom (–) key and select
the drawer size. The drawer sizes displayed are as given in
the table below.
Inch specifications
Display
(AtI)
(AtC)
(o2r)
Metric specifications
Metric specifications
Metric specifications
Drawer Size
Automatic Detection in inch units
Automatic Detection in centimeter
units (A⋅B columns)
Oficio II
3-3