Agilent Technologies XX3625 Service Manual page 124

Chapter 5: Troubleshooting
To configure the motherboard jumpers and set up the BIOS
Table 5-9 Series 757 System BIOS Settings with 120 Mbyte floppy drive
Configuration Item
Load Optimal Defaults
Standard Setup—Date/Time
Standard Setup—Floppy Drive A
Standard Setup—Floppy Drive B
Standard Setup—Pri Slave
Advanced Setup—System Keyboard
Advanced Setup—1st Boot Device
Advanced Setup—2nd Boot Device
PCI/PnP Setup—IRQ 9
Peripheral Setup (OnBoard Primary/Secondary IDE)
Power Management/APM
Hard Disk Power Down Mode
Hard Disk Time Out (minute)
Detect IDE Utility (Hard drive Primary Master)
Setting
YES
Enter current values
Not Installed
Not Installed
Floptical
Absent
Floptical
IDE-0
ISA
Primary
Enabled
Suspend
15 min
Data