Remote Arming With Telephone, Area 1 - Bosch D621 Series User Manual

D621 Series | User's Guide | Remote Arming With Telephone, Area 1
Remote Arming With Telephone,
Area 1
I can perform this command.
o
I cannot perform this command.
o
This function controls the built-in telephone arming feature
for Area 1. When enabled, the panel answers the phone on
the programmed ring count.
When the panel answers the phone, it
sounds three beeps and starts the handshake tone for
remote programming if the panel is All or Part On.
sounds one short beep, waits approximately 3 seconds,
and then sounds one long beep if the panel is off. Press
and hold the [5] key* for two seconds immediately after
the first short arming beep and before the long beep
begins.
Bosch Security Systems | 8/04 |
arms if it detects a [5] key press from the telephone (All
On with Delay, faulted points are force-armed). The panel
sounds three beeps (new armed state) and then hangs up.
* If arming from a cell phone, quickly press the [5] key
three times. If pressing and holding the [5] key for 2
seconds from a house (land-line) phone does not produce
a tone long enough to arm Area 1, retry by quickly
pressing the [5] key three times.
Remotely disarming the panel cannot be done with a
telephone.
52