Walk Test (Cmd 44) - Bosch D621 Series User Manual

D621 Series | User's Guide | Walk Test (Cmd 44)

Walk Test (Cmd 44)

o I can perform this command.
o I cannot perform this command.
Use this command to walk-test detection devices connected to
your system. Perform the walk test on a weekly basis. The
points included in the walk test are set by your security
company.
1. Make sure the system is turned off (All and Part indicators
are off).
2. Press [Cmd] [4] [4]. The keypad may prompt you to enter
a valid passcode by flashing the Cmd indicator.
3. Enter your passcode if necessary. The keypad emits a
single tone.
Bosch Security Systems | 8/04 |
4. To test each point, trigger the corresponding detection
device (such as open a door or walk in front of a motion
detector) until all points are tested. When a point is tested,
the keypad emits a single one second tone and the
corresponding point indicator turns on. When the tested
point is restored, the keypad emits a second single one
second tone and the corresponding point indicator turns
off.
5. To exit the walk test, press [Cmd]. The Status indicator
flashes rapidly. The walk test is over when the Status
indicator stops flashing.
Test fire detection devices (smoke/heat
detectors) weekly as instructed by your security
company and in accordance with the devices
instructions.
44