Extend Auto On Time (Cmd 51) - Bosch D621 Series User Manual

D621 Series | User's Guide | Extend Auto On Time (Cmd 51)
4. Enter the point number you want to watch followed by
the [*] key. (For example, press [5] [*] to watch Point 5.)
Repeat this step to select all the points you want to watch.
To turn Watch Mode off for a point, enter the point
number followed by the [*] key. (For example, press [5] [*]
to turn Watch off for Point 5.)
Figure 17: Current Watch Points
1 2 3 4 5 6
9 10 11 12 13 14 15 16
5. Press [Cmd] to exit this command.
Bosch Security Systems | 8/04 |
All Status
7 8
Part Cmd

Extend Auto On Time (Cmd 51)

o I can perform this command.
o I cannot perform this command.
Your security company can program your system to turn on
automatically. This command allows you to delay the auto-on
time by one hour during the auto-on pre-alert time.
1. Make sure the system is turned off (All and Part indicators
are off).
2. Press [Cmd] [5] [1]. The keypad may prompt you to enter
a valid passcode by flashing the Cmd indicator.
3. Enter your passcode if necessary. The keypad sounds a
valid tone.
49