Add A Passcode (Cmd 56) - Bosch D621 Series User Manual

D621 Series | User's Guide | Add A Passcode (Cmd 56)
Figure 15: Available User Numbers
1 2 3 4 5 6
9 10 11 12 13 14 15 16
4. Press [2] to change passcode authority levels. The
available user numbers now flash.
5. Enter the user number that you want to change the
authority level for, followed by the [*] key. (For example,
press [3] [*] to change the authority level for User 3). The
user number now turns on solid.
If the user does not exist in the system, the
keypad will emit an error tone.
6. Enter the new authority level (1 to 4) followed by [Cmd].
7. The available user numbers flash. Select another user, or
press [Cmd] twice to exit.
Bosch Security Systems | 8/04 |
Status
7 8 All
Part
Cmd

Add A Passcode (Cmd 56)

o I can perform this command.
o I cannot perform this command.
Use this command to add new passcodes to the system. This
command requires the appropriate authority level to add
passcodes. To add a new passcode to the system, you must
assign an area(s) to the new user in addition to using the other
Cmd 56 features (changing a passcode and changing a
passcode authority level) as outlined below. Only use this
feature under the direction of your security company.
1. Make sure the system is turned off (All and Part indicators
are off).
2. Press [Cmd] [5] [6]. The keypad may prompt you to enter
a valid passcode by flashing the Cmd indicator.
3. Enter your passcode. Point indicators 1, 2, and 3 flash.
4. Press [3] to assign an area(s) to the new user. The point
indicators flash to indicate available users.
33