D7412G, D7412, D7212G And D7212 Control Panels; Enter "Setup?" Function; Programming Custom Functions; Adding "Service Walk" To D7412G/ D7412/D7212G/D7212 Service Menu - Bosch D1260 Installation Manual

D1260/D1260B | Installation Guide | 4.0
The new number appears in the cell for User 249.
10. Click the Connect icon to connect to the control
panel.
11. Select Send RPS Data to Panel to send the
changes to the control panel.
12. Click OK to start the transfer.
The Send to panel dialog box appears with an
animation of blue dots moving from the PC icon to the
panel icon. The updating is complete when both
progress bars are full and the words "Synchronization
complete" appear.
The control panel is updated with the security
company's phone number.
4.3.2 D7412G, D7412, D7212G and D7212 Control
Panels
Follow the same steps in Section 4.3.1 D9412G, D9412
and D9112 Control Panels on page 13, except in Step 5,
use User 99 to enter the phone number.
4.4

99 + Enter "Setup?" Function

Access the Setup function by pressing [9] [9] [Enter],
Next>, Setup?>.
The adjustable functions available in this menu control
brightness and contrast (Figure 13 to Figure 15)

Figure 13: High Brightness Settings

Figure 14: Low Brightness Settings

14
Programming the Control Panel

Figure 15: Contrast Settings

Each of these selections have <- Level +> soft keys on
either side of the display that allows you to increase (+)
or decrease (-) the setting. The High and Low
Brightness are associated with Command 49's Bright
Display and Dim Display settings.
This menu also shows the Keypad address, whether the
Encoding Tone is On or Off, and the Keypad software
revision.
4.5

Programming Custom Functions

When programming Custom Functions for use on a
D1260/D1260B Keypad, program the keystrokes as if
you were using a D1255 Keypad. Refer to the control
panel's program entry guide and program record sheet
for full details on how to program Custom Functions.
4.6 Adding "Service Walk" to D7412G/
D7412/D7212G/D7212 Service
Menu
The Service Walk function does not appear as a soft
key in the Service Menu for D7412G, D7412, D7212G,
and D7212 control panels.
1. Double-click on the RPS icon.
2. Enter a valid username and password.
3. Double-click on the desired control panel.
4. Under "D9412 Program Record Sheet" locate the
section called "USER INTERFACE (9000MAIN)."
Bosch Security Systems | 9/04 | 48101E