Step 6, Connect Electrical; Step 7, Install Duct Covers - GE Monogram ZV830 Installation Instructions Manual

Installation Instructions
INSTALLATI O N--R ECIRCU LATI NG
_-1 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
if house wiring is not 2-wire
with a ground wire, a ground must be provided bLl
the installer. When house wiring is aluminum, be
sure to use U.L. approved anti-oxidant compound
and aluminum-to-copper connectors.
• Remove the 6 screws on the junction box cover
and the knockout on the top or left side.
Junction _"
box cover_ I \ _\
• Secure the house wiring to the junction box with
a strain relief.
• Connect the white lead to the branch circuit white lead.
• Connect the black lead to the branch circuit black lead.
• Connect the green/yellow lead to the branch
circuit green lead or bare ground lead.
• Secure all the connections with wire nuts on each
electrical connector.
• Push the wires into the junction box and replace
the cover. Be sure the wires are not pinched.
• Secure the junction box cover with the 6 original
screws.
17
INSTALL DUCT COVERS
• Remove protective plastic
covering.
• Place the decorative duct
covers on top of the hood.
NOTE: The inside piece has vent
holes on one end intended for
use when the hood is installed
for recirculating purposes. Be
sure the vented end is at the top;
the vent holes will be visible in
this installation.
The inside duct piece must slip
Mounting
screws
Vent holes
into the folded ends on the outer section.
J
Up_
duct cover
Lowe!
cover
.... _ Duct cover
support bracket
Lower duct
cover seat
Duct attachment
tabs
• Extend the inner duct upward to the ceiling
bracket.
'-__...._.o Screw holes
• Press up on the front corners of the filter cover panel
to unlock. Lower the panel to access the filter.
• Locate the screw holes on the inside front edge
of the opening. Install 2 screws to secure the duct
cover to the hood.