Electrical Service And Repair; Junction Box Installation - Heat & Glo Heat&Glo Escape-42DV Owner's Manual

PVK-80 POWERVENT
(WHITE)
(BLACK)
(BROWN)
(RED)
(ORANGE)
GROUND
BLACK
IPI
VALVE
FLAME
SOLENOID
(BLACK)
(WHITE)
(GROUND)
TO HEAT ZONE
NOTE 1: BROWN AND RED WIRES FROM
PVK-80 ARE FOR THE VACUUM SWITCH
NOTE 2: BLACK, WHITE AND GREEN WIRES
RUN PVK-80 MOTOR.
NOTE 3: GREEN WIRE FROM PVK-80 SHOULD
TIE INTO GROUND A THE JUNCTION BOX
WHERE 110V SERVICE IS REQUIRED.
Figure 12.2 IPI Wiring diagram for optional PVK-80 power vent termination cap
D. Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105° C rated wire. Wire must have high temperature
insulation.
E. Junction Box Installation
If the box is being wired from the INSIDE of the appli-
ance:
• Remove the screw attaching the junction box/receptacle
to the outer shell, rotate the junction box inward to dis-
engage it from the outer shell (see Figure 12.4).
• Pull the electrical wires from outside the appliance through
the opening into the valve compartment and secure wires
with a Romex connector. See Figure 12.4.
• Make all necessary wire connections to the junction
box/receptacle and reattach the junction box/receptacle
to the outer shell.
(GREEN)
(WHITE)
(BLACK)
(BROWN) (BROWN)
(RED)
(BROWN)
(GREEN)
IPI PILOT
IPI
(BROWN)
MODULE
(BROWN)
(RED)
(RED)
(BLACK)
(BLACK)
3V DC
(RED)
FLAME ON
(RED)
(ORANGE)
FLAME HIGH/LOW
(ORANGE)
(BLACK)
FAN
CONNECTION
(BLACK)
AC
PLUG
GROUND PIGTAIL
GREEN
Heat & Glo • Escape-42DV • 2052-900 Rev. X • 3/11
JUNCTION BOX
WHITE (HTL)
YELLOW (H&G)
RED
GREEN
REAR VIEW
G Y R
FRONT VIEW
(YELLOW)
FACTORY
CONNECTED
TOGETHER
(YELLOW)
FAN THEMOSTAT
(BLACK)
AUX
PLUG-ADP
CONNECTION
FIREBOX
BACK
LIGHT 1
BACK
LIGHT 2
43