Cisco DPC2420 User Manual page 71

Configure Advanced Settings
Configuring Port Forwarding for Local IP Addresses
Use the Setup Advanced Settings - Port Forwarding page to configure port
forwarding for local IP addresses. Port forwarding allows you to run a server on the
LAN by specifying the mapping of TCP/UDP ports to a local PC. You must also set
up a fixed private LAN IP address for the destination device.
Note: If you are not familiar with the advanced settings detailed in this section,
contact your service provider before you attempt to change any of the residential
gateway default advanced port forwarding settings.
Click Port Forwarding in the Advanced Settings section of the Setup page to access
the Setup Advanced Settings - Port Forwarding page.
Setup Advanced Settings - Port Forwarding Page
The following illustration is an example of the Setup Advanced Settings - Port
Forwarding page.
4021194 Rev A 51