Cisco DPC2420 User Manual page 61

Restarting the Gateway Modem
Use the Setup Basic Settings - Restart Cable Modem page to restart your cable
modem.
1 Click Restart Modem in the Basic Settings section of the Setup page to access the
Basic Settings - Restart Cable Modem page.
2 Click Reboot Cable Modem to restart the gateway modem.
Note: Restarting your gateway modem does not reset any of the settings.
Setup Basic Settings - Restart Cable Modem Page
The following illustration is an example of the Restart Cable Modem page.
Saving Your Configuration to a PC
Use the Setup Basic Settings - Save RG Configuration to Local PC page to save your
current cable modem RG configuration to the hard drive on your PC or to a floppy
disk. You will then be able to restore the RG configuration, if necessary.
Note: If you are not familiar with the procedures detailed in this section, contact
your service provider before you attempt to change any of the residential gateway
default settings.
Click Save Configuration to your PC in the Basic Settings section of the Setup page
to access the Setup Basic Settings - Save RG Configuration to Local PC page.
4021194 Rev A
Configure Basic Settings
41