Cisco DPC2420 User Manual page 52

Chapter 3 Configuring the DOCSIS Residential Gateway
Configuring Network Time Synchronization
Use the Basic Settings Enable/Disable time synchronization by Network Time
protocol page to enable or disable time synchronization by Network Time protocol.
Note: If you are not familiar with the time configuration procedures detailed in this
section, contact your service provider before you attempt to change any of the
residential gateway default time synchronization configuration settings.
Click Set Time in the Basic Settings section of the Setup page to access the Basic
Settings Enable/Disable time synchronization by Network Time protocol page.
Setup Basic Settings - Enable/Disable Time Synchronization by Network Time Protocol
The following illustration is the initial view of the Basic Settings Enable/Disable
time synchronization by Network Time protocol page.
Setup Basic Settings - Enable/Disable Time Synchronization by Network Time Protocol Page
Description
The following table provides a description of the fields within the Basic Settings
Enable/Disable time synchronization by Network Time protocol page.
Field Name
Current System Time
Network Time Protocol
32
Description
Displays the current system time and date
Allows you to enable or disable network time protocol
Note: The residential gateway will automatically use the time
server in your broadband network. Should there be no current
time displayed or if the network time is incorrect, enable
Network Time Protocol to use a public Internet time server to set
the clock in the gateway.
4021194 Rev A