Cisco DPC2420 User Manual page 113

Setup Wireless - Access Control Page Description
This section describes the section headings and field descriptions of the Setup
Wireless - Access Control page.
Field Name
Access restriction
Closed Network
Access List
Connected Clients
Function Keys
The following function keys appear on the Setup Wireless - Access Control page.
Key
Apply
Clear All
Remove
Add
4021194 Rev A
Description
When encryption is enabled, this selection allows you to choose one
of the following options from the drop-down list:

Disable (factory default)–No access restrictions based on MAC
address of wireless access devices

Allow–Allows wireless access to only the MAC addresses listed
in the Access List

Deny–Denies wireless access to only the MAC address listed in
the Access List
Allows you to disable or enable the network to access by wireless
clients. When ON is selected, the access point does not broadcast the
SSID. The client device must be configured manually with the SSID
and the MAC address of the access point in order to access with
wireless network.
Displays the MAC address of the clients that are subject to wireless
access control
Displays the Host Name, IP Address, and Client ID of wireless clients
that are connected to (associated with) the gateway modem
Description
Applies and saves the values you enter into the fields without closing
the screen
Clears the Access List
Removes entries from the Access List
Adds a client to the Access List using the MAC address of the client
Configure Wireless Settings
93