Toshiba 5000 Series User Manual page 190

S5 Command line editing character (user defined)
This register sets the character recognized as a backspace and pertains
to asynchronous only. The modem will not recognize the backspace
character if it is set to a value that is greater than 32 ASCII. This
character can be used to edit a command line. When the echo com-
mand is enabled, the modem echoes back to the local DTE the back-
space character, an ASCII space character, and a second backspace
character. This means a total of three characters are transmitted each
time the modem processes the backspace character.
Range: 0-255, ASCII decimal
Default: 8 (backspace)
Units: ASCII
S6 Wait before dialing
This register sets the length of time, in seconds, that the modem must
wait (pause) after going off-hook before dialing the first digit of the
telephone number. The modem always pauses for a minimum of three
seconds, even if the value of S6 is less that three seconds. The wait for
dial tone call progress feature (W dial modifier in the dial string) will
override the value in register S6. This operation, however, may be
affected by some ATX options according to country/region restric-
tions. In some regions, S6 will set dial tone detect time.
Range: 3-255
Default: 3
Units: seconds
S7 Connection completion time-out
This register sets the time, in seconds, that the modem must wait
before hanging up because carrier is not detected. The timer is started
when the modem finishes dialing (originate), or two seconds after
going off-hook (answer). In originate mode, the timer is reset upon
detection of an answer tone if allowed by county/region restriction.
The timer also specifies the wait for silence time for the @ dial modifier
in seconds. S7 is not associated with the W dial modifier.
Range: 1-255
Default: 50
Units: seconds
Appendix D
D-3