Toshiba 5000 Series User Manual page 184

&Wn Store current configuration
Saves the current (active) configuration (profile), including S-Regis-
ters.
The current configuration comprises a list of storable parameters.
These settings are restored to the active configuration upon receiving
a Zn command or at power up. Refer to the &V command.
&W0
Stores the current configuration as profile 0.
&W1
Stores the current configuration as profile 1.
Result codes:
n=0,1
OK
ERROR Otherwise
&Zn=x Store telephone number
This command is used to store up to four dialing strings in the
modem's nonvolatile memory for later dialing. The format for the
command is &Zn="stored number" where n is the location 0-3 to which
the number should be written. The ATDS=n command dials using the
string stored in location n.
Result codes:
n=0,1,2,3
OK
ERROR Otherwise
\Nn Error control mode selection
This command determines the type of error control used by the modem
when sending or receiving data.
\N0
Buffer mode. No error control.
\N1
Direct mode.
\N2
MNP or disconnect mode. The modem attempts to connect
using MNP2-4 error control procedures. If this fails, the
modem disconnects.
This is also known as MNP reliable mode.
Appendix C
C-11