Toshiba 5000 Series User Manual page 179

User's Guide
N1
When originating or answering, begin the handshake at the
communication standard specified by S37 and the ATB
command (default).
During handshake, a lower transmission speed may be
selected.
Result Codes:
n=0,1
OK
ERROR Otherwise
On Return on-line to data mode
O0
Instructs the modem to exit on-line command mode and return
to data mode (see Escape Sequence section).
O1
This command issues a retrain before returning to on-line data
mode.
O3
This command issues a rate renegotiation before returning to
on-line data mode.
Result Codes:
n=0,1,3
OK
ERROR Otherwise
P Select pulse dialing
This command configures the modem for pulse (non touch-tone)
dialing. Dialed digits are pulsed until a T command or dial modifier is
received. Tone dial is the default setting.
Qn Result code control
Result codes are informational messages sent from the modem and
displayed on your monitor. Basic result codes are OK, CONNECT,
RING, NO CARRIER, and ERROR. The ATQ command allows the
user to turn result codes on or off.
Q0
Enables modem to send result codes to the computer (de-
fault).
Q1
Disables modem from sending result codes to the computer.
Result Codes:
n=0,1
OK
ERROR Otherwise
C-6