Stanley Supreme DF User Manual page 32

Gas Connection
Fitting a stability bracket
A stability bracket or chain (not supplied with the cooker)
should be fitted when the cooker is connected to a flexible
gas supply. Any restraining device should be secured to
the fabric of the building and should be able to be released
so that the cooker can be pulled out for cleaning and
maintenance.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
a. Position and level the appliance.
b. Draw a pencil line along the front edge of the base of
the cooker and along the right hand edge.
c. Remove the range.
d. Mark off 495mm from the RH side of the unit to indicate
the centre line for the bracket.
e. Mark off 415mm to locate the front edge of the lower
bracket. Fix bracket to floor.
f. Measure the height from floor level to the bottom of the
opening in the cooker back. Add 3mm to this
dimension and assemble the stability bracket to this
height (i.e. from floor level to underside of top
member).
Gas Connection
The gas supply need to terminate with a down facing
bayonet. The rear cover boxes limit the position of the
supply point.
32