Table of Contents
Advertisement
FX
OUTPUT MIX (MULTIFX1 AND 2 ONLY)
Pressing OUTPUT MIX in the main MULTIFX page shows this screen:
Here you may balance the various multiFX sections. The parameters are:
DIST/EQ LEVEL
DIST/EQ PAN
MOD/DEL LEVEL
MOD/DEL PAN
MOD/DEL WIDTH
REVERB LEVEL
REVERB PAN
NOTE: REVERB LEVEL and REVERB PAN are duplications of the parameters found in the
main reverb pages and are included here for convenience.
DIRECT SIGNAL
210
Sets the output level of the RING MOD/DISTORTION/EQ block of effects.
Sets the pan position of the RING MOD/DISTORTION/EQ block of
effects.
Sets the level of the MODULATION/DELAY effects.
Sets the stereo balance of the MODULATION/DELAY effects.
Sets the width of the stereo image. At a value of 100, maximum stereo is
obtained but set lower than that and the sound becomes gradually
narrower. At a value of 0, the output from the MODULATION/DELAY
section is mono.
This sets the level of the reverb in the multiFX chain.
This sets the stereo balance of the reverb in the multiFX chain.
You can switch out the direct signal from the multiFX chain. This is of
most relevance when using effects such as autopan or rotary speakers
although it can be useful in other circumstances.
s5000 / s6000
Version 1.21
Advertisement
Table of Contents
