WARNING
Handle glass with care.
•
Inspect the gasket to ensure it is
undamaged.
•
Inspect the glass for cracks, chips or
scratches.
•
Do NOT strike, slam or scratch glass.
•
Do NOT operate appliance with glass
assembly removed, cracked, broken or
scratched.
•
Replace glass assembly as a complete
assembly.
G. Replace Glass Assembly
•
Set the glass panel on the lower two or four glass assembly
latches, ensuring the glass panel is centered in the
opening.
•
Pull out and latch all four or seven glass assembly latches
into the groove on the glass frame.
H. Install Clean Face Components
Carefully remove components from skin pack. See Figure
12.3 for identifi cation of components.
Bottom Latch Cover
Hood
Firescreen
(Lower Floor Cover-not shown-
shipped underneath)
Figure 12.3 Clean Face Components/Skin Pack
26
Top Latch Cover
Firescreen Rod
Heatilator • Novus BV-Mesh • 4031-553 Rev F • 11/07
Install Hood
•
Bend screen rod tabs down at a 90-deg. angle. See Figure
12.4.
Figure 12.4 Screen Rod Tab
•
Install above the glass panel.
•
Hood must be attached or a fi re hazard may result.
•
Locate the four screws just inside the upper section of the
appliance.
•
Position hood and slide notches over screw heads.
•
Tighten the four screws.
•
See Figure 12.5.
Figure 12.5 Installing the Hood
Install Top Latch Cover
•
Insert top latch cover tabs into slots. See Figure 12.6.
•
Rotate top latch cover down till the tabs lock in place.
Top Latch
Cover Tab
Figure 12.6 Installing Top Latch Cover
Slot