Removing Memory (With Optional Memory Riser Cards) - Dell Precision Workstation 690 User Manual

2 thumbscrews (2)
NOTICE: The memory shroud holds the (optional) memory risers in place; its thumbscrews must be sufficiently tight in order to secure the risers and to
avoid damage.
17. Replace the memory shroud. Tighten the thumbscrews until the memory shroud is well secured and will not shift when the computer is moved.
18. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
19. Connect your computer and devices to electrical outlets, and turn them on.
20. Press <F2> to enter system setup and check the values listed under Memory Info.
The computer should have changed the value of Installed Memory to reflect the newly installed memory. Verify the new total. If it is correct, skip to
step 14.
21. If the memory total is incorrect, turn off and disconnect your computer and devices from their electrical outlets.
Return to step 1 of this procedure, but instead of installing new memory, check the installed memory modules to ensure that they are seated properly in
their sockets.
22. When the Installed Memory total is correct, press <Esc> to exit system setup.
23. Run the Dell Diagnostics to verify that the memory modules are operating properly. See
Removing Memory (With Optional Memory Riser Cards)
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer.
1. Follow the procedures in Before You
CAUTION: Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before
attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See
your Product Information Guide for other important safety information.
CAUTION: The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the
computer tipping over, potentially resulting in bodily injury or damage to the computer.
2. Remove the computer cover (see
1 memory shroud
2 thumbscrews (2)
Replacing the Computer Cover).
Begin.
Removing the Computer Cover).
Dell Diagnostics.