Removing A Pci Express Graphics Card From A Dual Configuration - Dell Precision Workstation 690 User Manual

Removing a PCI Express Graphics Card from a Dual Configuration
This section regards dual configurations of PCI Express graphics cards only. For removal of any other types of PCI or PCI Express cards, see
Expansion Card.
NOTE: To upgrade to or downgrade from a dual-graphics configuration, you will need additional parts that can be ordered from Dell. See
1. Follow the procedures in Before You
CAUTION: Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before
attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See
your Product Information Guide for other important safety information.
CAUTION: The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the
computer tipping over, potentially resulting in bodily injury or damage to the computer.
2. Remove the computer cover (see
1 card retention device
2 tab
3. Press the tabs on either end of the card retention device and lift to remove it from the computer.
4. Gently securing both graphics cards with one hand, remove the graphics card bridge (if present) with your other hand by pulling it up and away from the
computer. Set it aside.
1 graphics card bridge (not present on some dual-graphics configurations)
2 power connectors (2)
3 dual-PCI Express graphics cards
5. Disconnect any cables connected to the card.
Begin.
Removing the Computer Cover).
Removing an
Contacting Dell.