Removing Memory Riser Boards - Dell Precision 530 Service Manual

Dell precision 530: service manual
Hide thumbs Also See for Precision 530:
Table of Contents

Advertisement

50
I n s t a l l i n g a M e m o r y M o d u l e
securing clips (2)
memory socket
slots (2)

Removing Memory Riser Boards

NOTICE:
Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see
Components."
Remove the microprocessor airflow
1
Remove the memory riser board retention bracket (see the following
2
figure).
Lift the retention bracket up to disengage it from the chassis.
a
Lift the bracket away from the chassis.
b
NOTICE:
To avoid damage to the memory riser board, press the securing clips
with equal force applied at each end of the memory socket.
Remove memory riser board A:
3
NOTE:
To access the securing clips on the system board memory sockets,
it may be necessary to remove the
Press the securing clips of system board memory socket 1 outward
a
simultaneously until riser board A pops out slightly from the
socket.
shroud.
fan for microprocessor
0.
"System Board

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents