Attaching The Computer Stand - Dell Precision Workstation 690 User Manual

Hide thumbs Also See for Precision Workstation 690:
Table of Contents

Advertisement

Back to Contents Page
  Computer Stand
Dell Precision™ Workstation 690 User's Guide
  Attaching the Computer Stand
  Removing the Computer Stand
 
CAUTION:
Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before
attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See
your Product Information Guide for other important safety information.
 
CAUTION:
The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the
computer tipping over, potentially resulting in bodily injury or damage to the computer.
 
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
 
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer.
 Attaching the Computer Stand
 
CAUTION:
Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before
attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See
your Product Information Guide for other important safety information.
 
CAUTION:
The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the
computer tipping over, potentially resulting in bodily injury or damage to the computer.
 
1. Follow the procedures in
Before You
 
2. If you have installed a security cable, remove it from the security cable slot.
 
3. Set the stand on the ground in front of the computer, so that the front and the back of the stand touch the ground.
If the front and the back of the stand point up toward the ceiling, the stand is upside down.
 
4. Ensure that the alignment guide faces the computer.
If the alignment guide points away from the computer, the stand is backwards.
1 computer
2 computer stand
3 alignment guide
 
5. Align the center of the stand with the center of the computer.
 
6. Carefully, with the help of an assistant, tilt the computer backwards slightly- just high enough to slide the stand beneath it.
 
Begin.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents