Installing A Floppy Drive - Dell Precision Workstation 690 User Manual

b. Install a drive panel insert (see
9. If you are installing another drive in the drive bay, see the appropriate installation instructions.
10. Reinstall the drive panel (see
11. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
12. Connect the computer and devices to electrical outlets, and turn them on.

Installing a Floppy Drive

1. Follow the procedures in Before You
CAUTION: Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before
attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See
your Product Information Guide for other important safety information.
CAUTION: The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the
computer tipping over, potentially resulting in bodily injury or damage to the computer.
2. Remove the computer cover (see
3. Remove the drive panel (see
4. If installed, remove the 3.5-inch drive-panel insert (see
Ensure that the 3.5-inch drive panel plate is installed.
5. If another device is installed in the drive bay, remove that device (see the appropriate device removal instructions).
6. If no screws are attached to the drive, check the inside of the drive panel for shoulder screws. If screws are present, attach the screws to the new
drive.
1 floppy drive
2 screws (4)
7. If an empty 3.5-inch drive carrier is installed in the drive bay, slide the floppy drive into the drive carrier until it clicks into place.
Otherwise:
a. Slide the floppy drive into the 3.5-inch drive carrier until it clicks into place.
b. Then, while pressing down the release lever on the side of the drive carrier, slide the drive carrier into the drive bay until it clicks into place.
Replacing a Drive-Panel Insert).
Replacing the Drive Panel).
Replacing the Computer Cover).
Begin.
Removing the Computer Cover).
Removing the Drive Panel).
Removing a Drive-Panel Insert).