Mounting; Orientation; Rigging - Chauvet COLORdash Batten User Manual

Mounting

Orientation

This fixture may be mounted in any safe position.

Rigging

The fixture includes a mounting yoke to which a rigging clamp can be attached. You
must supply your own clamp and make sure the clamp is capable of supporting the
weight of this fixture. You can order "C" and "O"-clamps from any CHAUVET dealer
or distributor (CLP-15, CLP-06 recommended).
If hanging the fixture for over head use, then please follow the below steps.
Caution! After prolonged periods of operation, the fixture chassis may reach high
temperatures. This fixture must be mounted in a ventilated location, as it uses
Hanging Clamp
Note: sold separately
COLORdash™ Batten User Manual
Note: There are 2 types of applications for this fixture: floor stand for up lighting, and
overhead use for down lighting. If you are using this fixture in a hanging/mounted
application, then you must use at least 1 safety cable/chain for each fixture in addition to
the mounting brackets.
1. Block access below the work area and use suitable and stable platform
when installing or servicing fixture.
2. Safety cables must always be used, secured
ventilation passageway
times the weight of the fixture.
3. Verify the structure can hold 10 times the weight of all to-be installed
fixtures.
forced convection cooled.
through the heat sink
. The safety cable must be capable of holding 10
Hanging Bracket/
Floor Stand
9
9/5/2008 9:49 AM