Table of Contents
Advertisement
Upload Customs
The custom programs in the COLORdash™ Batten may be copied from one fixture to another,
thus giving the ability to have to only program them on a single fixture, and then duplicate this on
several others. This is accessed in the Control Panel as "Upload". Follow the below steps for this
process. On all fixtures that are going to receive the upload, set them on SLAVE operation.
1.
Disconnect from DMX controller
Select "Settings" in the Control Board and press Enter.
2.
Select "Upload Customs" and press enter.
3.
Press enter to confirm or enter password, then press enter. "Uploading customs" will
4.
display when the transfer is proceeding.
5.
If the upload is successful, then the slave fixtures will show green. If the upload is
unsuccessful, then the slave fixtures will show red.
Note: you must enter the password on the unit sending the custom programs to the other
units. If you have not yet set a password on the unit, then you may leave it blank and
just press "ENTER".
Note: the units receiving the new custom programs from the master must be set to
"SLAVE". Otherwise, they will not allow receipt of the programs.
COLORdash™ Batten User Manual
17
9/5/2008 9:49 AM
Advertisement
Table of Contents
